Transmission Removal - Page 3

By: Jmihalchik

37.) Locate Vehicle speed sensor, push red tab out ward and unhook. 38.) next place a jack under motor, and under trans, just enough to hold weight not jack up trans or motor (can damage oil pan). Next locate the trans mount bolt. If you do not take the weight off the mount you can ruin the bolt. 38.) Next lower the jacks enough to get to the tranny mount bracket bolts. (15mm) 39.) Next loosen the 2 upper motor to trans bolts (18mm) 40.) Lower tranny jack and remove transmission. Torque Required: Wheels : 95 Ft lbs Strut To Knuckle : 40ft lbs Intermediate Shaft bracket to block : 40 ft lbs Intermediate shaft to bracket : 250 inch lbs ( roughly 21 ft lbs) Axel Nut to Hub : 180 Ft lbs Flywheel to crankshaft : 70 ft lbs Trans to motor bolts : 80 ft lbs Clutch to drive plate bolts : 65 ft lbs Shift cable bracket to trans : 250 inch lbs (21 ft lbs) Drain plug (tranny ) 17 ft lbs Trans mount to trans : 50 ft lbs Structural Collar: horizontal bolts 80ft lbs, vertical 40 ft lbs lateral brace : 45 ft lbs Abs wheel sensor :105 inch lbs (8 ft lbs) Throttle Body 250 inch lbs (21 ft lbs) tie rod : 40 ft lbs

< Previous Page